Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8Fence Installation 1. Install a pair of gate posts first. (If you don’t have any gates, then start with an end or corner post). Dig the post holes and set the posts into them. Fill the holes with concrete and tamp down around each post so the concrete is about 2” below ground level. The gate will be attached after the concrete has set. Single Gate Post Spacing To accommodate different hardware mounting options, the opening between the posts should equal the size of the gate that was ordered PLUS 1/2” (i.e., If you ordered a 48” gate, space your posts at 48 1/2” inside to inside). Please Note: When we fabricate our gates we deduct 1” from the width to accommodate for the hinges and latch leaving a 1 1/2” gap on all. Gate Width Ordered Spacing Between Posts Actual Gate Width Overall Gap 36” 36 1/2” 35” 1 1/2” 48” 48 1/2” 47” 1 1/2” 60” 60 1/2” 59” 1 1/2” 72” 72 1/2” 71” 1 1/2” 96” 96 1/2” 95” 1 1/2” 120” 120 1/2” 119” 1 1/2” 144” 144 1/2” 143” 1 1/2” 168” 168 1/2” 167” 1 1/2” Double Gate Post Spacing To accommodate different hardware mounting options, the opening between the posts should equal the size of the gate that was ordered PLUS 1/2” (i.e., If you ordered a 96” double gate, space your posts at 96 1/2” inside to inside). Please Note: When we fabricate our gates we deduct 1” from the width of each leaf to accommodate for the hinges and latch leaving a 2 1/2” gap on all. Gate Width Ordered Spacing Between Posts Actual Gate Width Overall Gap 96” 96 1/2” 94” (47” each leaf) 2 1/2” 120” 120 1/2” 118” (59” each leaf) 2 1/2” 144” 144 1/2” 142” (71” each leaf) 2 1/2” 168” 168 1/2” 166” (83” each leaf) 2 1/2” 192” 192 1/2” 190” (95” each leaf) 2 1/2” 216” 216 1/2” 214” (107” each leaf) 2 1/2” 240” 240 1/2” 238” (119” each leaf) 2 1/2” 2. Repeat this procedure for all other gate posts that are not in the same straight line of fence. Gates that are in the same line will be installed when the fence reaches their location. 3. After the gate posts are set, the first line of fence is ready to be installed. Mark post centers at 72 1/2” using a tape measure and marking paint. Dig up to 8-10 holes for the posts along the fence line.