Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8Installation Tips • All screws in the fence sections and the posts should be installed on the same side (normally the inside of the enclosed area for a neater appearance when you are done. • When you need less than a full section to complete a line of fence, cut it to size using a hacksaw or sawzall. Measure inside to inside the posts where the cut section is going to be installed. Add 1 1/2” to the inside to inside measurment to achieve the section length. Notch the cut ends of the horizontal rails approximately 1/4” x 3/4” so they will fit inside the post. Use a factory notch as a guide. • Mix the concrete for the post holes on the dry side to allow the posts to set faster and to give additional support when installing the fence section. NOTE: The concrete footing must extend below the frost line in areas where freezing of the ground can cause the posts to “heave”. The posts themselves do not have to go below the frost line for proper installation.